Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Tesla Model SFACTORY OEM SERVICE PROCEDURE
Media Control Unit - Remove And Install: Notes
Last modified: 21/03/2022 15:05:57
Special tool required for this procedure:
| Supplier | Part Number | Description |
|---|---|---|
| Tesla | 1065660-00-A | ESD FOAM CONTAINER FOR MEDIA CONTROL UNIT |
NOTE:
This procedure removes and then installs the same media control unit. To replace a media control unit, refer to SI-20-21-005 for Atom, and SI-20-21-014 for Tegra.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.