Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Tesla Model SFACTORY OEM SERVICE PROCEDURE
Image Capture - Forward Facing Camera: Setup
- If the vehicle is equipped with air suspension, set the ride height to Standard.
- Place the target tripod in the appropriate starting position:
- The target is placed against the front fascia and centered on the Tesla "T."
- The target has 2 legs facing the vehicle and both are less than 5 mm from the lower valance.
- The target and vehicle are both on a flat surface.NOTE: If a flat surface is unavailable, ensure that the vehicle and target are both on the same slope.
- Ensure that the target is on flat ground by examining the bubble level on the back of the target.
- Apply a piece of colored tape onto the target so that the top edge of the tape is 130 cm from the ground.
- Connect a laptop with Toolbox to the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
