Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Tesla Model SFACTORY OEM SERVICE PROCEDURE
Image Capture
NOTE:
Do not sit in or lean on the vehicle during image capture.
- In Toolbox 3, go to Dashboards > Service Tools > View DAS Images > Image Capture .
- Exit the vehicle with the laptop.
- Click Capture Image in the lower right corner of the DAS Image Viewer screen.
- In the "Main" and "Narrow" camera views, determine if the top edge of the tape is between the positive 1 and negative 3 green degree lines.NOTE: The "positive" degree lines are below the main horizontal axis. The "negative" degree lines are above the main horizontal axis.
1 Positive 1 green degree line 2 Tape 3 Negative 3 green degree line - If the top edge of the tape is not between the green degree lines, retrofit a triple camera rear view mirror mount plate with integrated pitch adjustment, refer to TRIPLE CAMERA PITCH ADJUSTMENT - FORWARD FACING - 2ND GENERATION AUTOPILOT (RETROFIT) .
- If the top edge of the tape is between the green degree lines, no further pitch adjustment is necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
