Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Tesla Model SFACTORY OEM SERVICE PROCEDURE
Module - Intrusion Sensor - Remove And Replace: Removal
- Use a trim tool to release the clips (x2) that attach the rear of the overhead console, and then pull the rear of the overhead console down.NOTE: Make sure not to damage the harness connections inside of the headliner.
- Disconnect the headliner electrical harness from the microphone connectors (x2) and the intrusion sensor connector, and then remove the overhead console with the intrusion sensor module from the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.