Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSCONTINUOUSLY VARIABLE TRANSAXLE (CVT)SPECIFICATIONSTIGHTENING TORQUE SPECIFICATIONS
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Tightening Torque Specifications
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Tightening Torque Specifications
CAUTION:
For fastener with * (asterisk) below, be sure to tighten it according to specified procedure in "Repair Instructions".
TIGHTENING TORQUE SPECIFICATIONS
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kgf-m | lbf-ft | |
| Fluid pressure check hole bolt | 7.5 | 0.76 | 5.5 |
| CVT fluid drain plug | 34 | 3.5 | 25.0 |
| Transmission range sensor bolt | 5.9 | 0.60 | 4.5 |
| Manual select lever nut | 17 | 1.7 | 12.5 |
| Primary pulley speed sensor bolt | 5.9 | 0.60 | 4.5 |
| Secondary pulley speed sensor bolt | 5.9 | 0.60 | 4.5 |
| Oil strainer bolt | 7.9 | 0.81 | 6.0 |
| CVT oil pan bolt* | 7.9 | 0.81 | 6.0 |
| Valve body bolt | 7.9 | 0.81 | 6.0 |
| Manual valve body nut | 22 | 2.2 | 16.5 |
| Oil strainer bracket bolt | 7.9 | 0.81 | 6.0 |
| Solenoid harness bolt | 7.0 | 0.71 | 5.5 |
| CVT fluid cooler bracket bolt* | 25 | 2.5 | 18.5 |
| CVT fluid cooler bolt | 13 | 1.3 | 9.5 |
| Torque converter No. 1 and No. 2 bolt | 23 | 2.3 | 17.0 |
Reference:
For the tightening torques of fasteners not specified in this Service Information, refer to:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.