Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Main Fuel Level Sensor
Reference: MAIN FUEL LEVEL SENSOR REMOVAL AND INSTALLATION
Check resistance between terminals (1) and (2) at each float position [a], [b] and [c].
If measured resistance is out of specification, replace main fuel level sensor.
Main fuel level sensor resistance
| Float position | Resistance | |
|---|---|---|
| [a] | 208 mm (8.19 in.) | 19.0 - 21.0 Ω |
| [b] | 92.3 mm (3.63 in) | 79.4 - 89.4 Ω |
| [c] | 40.4 mm (1.59 in) | 129.0 - 132.4 Ω |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.