Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Suzuki SX4 BaseFACTORY OEM SERVICE PROCEDURE
DTC Troubleshooting
WARNING: This page is about a different variant/trim than selected.
DTC P0602 TROUBLESHOOTING CHART
| Step | Action | YES | NO |
|---|---|---|---|
| 1 | DTC recheck
Is DTC P0602 still detected? |
Go to Step 2. | Check for intermittent trouble. See INTERMITTENT AND POOR CONNECTION INSPECTION |
| 2 | TCM reprogramming check Was reprogramming of TCM executed? |
Execute reprogramming of TCM correctly once again. | Go to Step 3. |
| 3 | TCM power and ground circuit check
Is it in good condition? |
Substitute a known-good TCM and recheck. | Repair or replace defective wire harness. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.