Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Suzuki SX4 BaseFACTORY OEM SERVICE PROCEDURE
Tightening Torque Specifications
TIGHTENING TORQUE SPECIFICATIONS
| Fastening part | Tightening torque | Note | ||
|---|---|---|---|---|
| N.m | kgf-m | lbf-ft | ||
| Starting motor cable nut | 11 | 1.1 | 8.5 | Refer to STARTING MOTOR REMOVAL AND INSTALLATION . |
| Starting motor mounting bolt | 45 | 4.6 | 33.5 | Refer to STARTING MOTOR REMOVAL AND INSTALLATION . |
| Brush holder screw | 3.5 | 0.36 | 3.0 | Refer to STARTING MOTOR REMOVAL AND INSTALLATION . |
| End frame bolt | 6.0 | 0.61 | 4.5 | Refer to STARTING MOTOR DISASSEMBLY AND REASSEMBLY . |
| Magnetic switch screw | 6.0 | 0.61 | 4.5 | Refer to STARTING MOTOR DISASSEMBLY AND REASSEMBLY . |
| Lead wire nut | 10 | 1.0 | 7.5 | Refer to STARTING MOTOR DISASSEMBLY AND REASSEMBLY . |
NOTE:
The specified tightening torque is described in the following.
STARTING MOTOR COMPONENTS
STARTING MOTOR COMPONENTS
Reference:
For the tightening torque of fastener not specified in this service information, refer to FASTENERS INFORMATION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.