2012 Suzuki SX4 BaseFACTORY OEM SERVICE PROCEDURE

Generator Inspection: Pulley

  • Check pulley for wear, damage or other abnormal conditions.
  • For CVT model, check pulley according to the following procedures.
    1. Fix center of pulley.
    2. Check that pulley locks up when turned in clockwise direction [a] and rotates smoothly in counterclockwise direction [b]. If faulty condition is found, replace pulley.
      Fig 1: Checking Pulley
      G06867298Courtesy of SUZUKI OF AMERICA CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.