2012 Suzuki Grand Vitara BaseFACTORY OEM SERVICE PROCEDURE

IMRC Valve Motor Check

NOTE: The IMRC valve actuator may be damaged if battery voltage is applied to it for longer than 10 seconds.
Limit the time of battery voltage application to the IMRC valve actuator to no more than 10 seconds.
  1. Remove IMRC valve. Refer to INTAKE MANIFOLD REMOVAL AND INSTALLATION
  2. Using ohmmeter, measure resistance between terminals "4" and "5" of IMRC valve actuator connector.

    If faulty condition is found, replace IMRC valve (2).

    IMRC valve motor resistance 

    8 - 10 Ω at 20 °C (68 °F) 

  3. Connect battery (1) to terminals "4" and "5" of IMRC valve actuator connector as shown in figure.

    Check if IMRC valve is at fully open position.

    Fig 1: Connecting Battery To Terminals 4 And 5 Of IMRC Valve Actuator Connector
    G08895378Courtesy of SUZUKI OF AMERICA CORP.
  4. Connect battery (1) to terminals "4" and "5" of IMRC valve actuator connector as shown in figure.

    Check if IMRC valve is at fully closed position.

    If faulty condition is found, replace IMRC valve (2).

    Fig 2: Connecting Battery To Terminals 4 And 5 Of IMRC Valve Actuator Connector
    G08895379Courtesy of SUZUKI OF AMERICA CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.