2012 Suzuki Grand Vitara BaseFACTORY OEM SERVICE PROCEDURE

Tightening Torque Specifications

Fastening part Tightening torque Note
N.m kgf-m lbf-ft
Yaw rate/G sensor assembly bolt 8 0.8 6.0 Refer to Yaw Rate/G Sensor Assembly Removal and InstallationΒ .

Reference:Β 

For the tightening torques of fasteners not specified in this page, refer to: FASTENER INFORMATION

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.