2012 Suzuki Equator BaseFACTORY OEM SERVICE PROCEDURE

A/T Shift Lock System: System Description

WARNING: This page is about a different variant/trim than selected.
  • The selector lever cannot be shifted from "P" (Park) unless the brake pedal is applied and the ignition switch is in the "ON" position.
  • Battery voltage is supplied to the shift lock solenoid by the stop lamp switch.
  • Ground is supplied to the shift lock solenoid by the park position switch (shift selector).
  • With the ignition switch "ON", brake pedal applied and the A/T shift selector in "P" (Park), the shift lock solenoid is energized, allowing the selector lever to be shifted from Park.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.