WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The cruise control ON/OFF switch must be ON in order to properly measure the resistance of the - SET, the + RES, and the Cancel switches.

Steering Wheel Controls Switch - Left

Ignition OFF, remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
Ignition OFF, disconnect the steering wheel controls switch - left.
Cruise switch ON, measure the resistance between terminals 1 and 3 at the cruise control switch side of the connector. Individually activate and hold each cruise control function switch and compare the resistance reading to the values on the schematic for the ON/OFF, SET -, the RES +, and the Cancel switches.
- If any of the resistance measurements for the OFF, ON, SET -, RES + and Cancel switches are not within the listed resistance values, replace the steering wheel controls switch - left.

FUNCTION SWITCH RESISTANCE VALUE

Function Switch	Minimum Resistance Value	Maximum Resistance Value
OFF	O.L.	O.L.
ON	6.5 kΩ	7.0 kΩ
- SET	2.2 kΩ	2.4 kΩ
+ RES	3.7 kΩ	3.8 kΩ
Cancel	1.4 kΩ	1.6 kΩ

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Component Testing: Notes

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?