WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Windshield Washer System Module Assembly And Bolts

Courtesy of SUZUKI OF AMERICA CORP.

WIPER MOTOR TABLE

Callout	Component Name
Preliminary Procedure Remove the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT .
1	Windshield Washer System Module Assembly Bolts (Qty: 3) CAUTION: Refer to FASTENER NOTICE . Tightening torque Tighten the bolts in the mandatory sequence as shown to 12 N.m (9 lb ft)
2	Windshield Washer System Module Assembly Raise the module from the plenum and disconnect the electrical connector from the wiper motor. Re-connect the electrical connector prior to the installation of the wiper washer module back into the plenum.
3	Windshield Washer Module Assembly Harness
4	Windshield Washer Module Assembly Harness Rosebud Tip: Ensure the rosebud is fastened to the plenum flange to ensure the harness is secure.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Wiper Motor Module Replacement

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?