Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Suzuki Equator BaseFACTORY OEM SERVICE PROCEDURE
Section 17 (Security And Locks)
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- General Description
- Power Door Locks Description and Operation
- Rear Hatch / Gate Description and Operation
- Keyless Entry System Description and Operation
- Notes
- Keyless Entry Transmitters
- Keyless Entry Antenna
- Remote Control Door Lock Receiver (RCDLR)
- Unlock Driver Door Only
- Unlock All Doors - Second Operation
- Lock All Doors - Active
- Liftglass Release
- Power Liftgate
- Panic Alarm / Vehicle Locator
- Remote Vehicle Start (RVS)
- Enable / Disable RVS
- Hood Ajar Switch
- Circuit Description (RVS)
- Keyless Entry Personalization
- Rolling Code
- Automatic Synchronization
- Content Theft Deterrent (CTD) Description and Operation
- Key and Lock Cylinder Coding
- Schematic and Routing Diagram
- Component Location
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Vehicle Access
- Diagnostic Starting Point - Remote Functions
- Diagnostic Starting Point - Theft Deterrent
- Scan Tool Output Controls - Vehicle Access
- Scan Tool Output Controls - Remote Functions
- Scan Tool Data List - Vehicle Access
- Scan Tool Data List - Remote Functions
- Scan Tool Data List - Theft Deterrent
- Scan Tool Data Definitions - Vehicle Access
- Scan Tool Data Definitions - Remote Functions
- Scan Tool Data Definitions - Theft Deterrent
- DTC Table
- DTC B2495
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit / System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit / System Verification
- Circuit / System Testing
- Repair Instructions
- DTC B3105
- DTC B3109
- DTC B3110
- DTC B3111
- DTC B3112
- DTC B3125, B3130, or B3135
- DTC B3140, B3145, B3150, or B3155
- DTC B3265
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit / System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit / System Verification
- Circuit / System Testing
- Repair Instructions
- Symptoms - Vehicle Access
- Symptoms - Remote Functions
- Symptoms - Theft Deterrent
- Liftgate Release Inoperative
- Power Door Locks Inoperative
- Keyless Entry System Inoperative
- Remote Vehicle Start Inoperative
- Content Theft Deterrent Malfunction
- Security Indicator Malfunction
- Repair Instructions
- Opening the Liftgate without Electrical Power
- Front Side Door Lock Cylinder Replacement
- Front Side Door Latch Replacement
- Rear Side Door Latch Replacement
- Liftgate Latch Replacement
- Front Side Door Lock Striker Adjustment
- Front Side Door Lock Striker Replacement
- Rear Side Door Lock Striker Adjustment
- Rear Side Door Lock Striker Replacement
- Liftgate Lock Striker Adjustment
- Liftgate Lock Striker Replacement
- Power Door Lock Switch Replacement
- Transmitter Battery Replacement
- Transmitter Programming
- Remote Control Door Lock Receiver Replacement
- Remote Control Door Lock Receiver Antenna Replacement
- Remote Control Door Lock Receiver Programming and Setup
- Theft Deterrent Module Replacement
- Theft Deterrent Control Module Programming and Setup
- Specifications
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.