Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Suzuki Equator BaseFACTORY OEM SERVICE PROCEDURE
Installation Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Install the negative battery cable to the wiring loom and re-tape the loom.
- Install the negative battery cable ground terminal (1) to the transaxle stud.CAUTION: Refer to FASTENER NOTICE .
- Install the negative battery cable ground terminal nut (2) to the transaxle stud.
Tightening torque
Tighten the nut to 45 N.m (33 lb ft).
- Install the negative battery cable ground terminal to the wheelhouse stud.
- Install the negative battery cable ground terminal nut to the wheelhouse stud.
Tightening torque
Tighten the nut to 12 N.m (106 lb in).
- Connect the body wiring harness electrical connector (4) to the battery current sensor (5).
- Connect the negative battery cable electrical connector (7) to the body wiring harness electrical connector (2).
- Connect the positive and negative battery cable clip (3) to the battery tray support bracket.
- Connect the positive and negative battery cable clip to the side of the battery tray support bracket.
- Install the battery box. Refer to INSTALLATION PROCEDURE .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
