2012 Suzuki Equator BaseFACTORY OEM SERVICE PROCEDURE

Methods Of Preventing Over-Discharge

The following precautions must be taken to prevent over-discharging a battery.Β 

  • The battery surface (particularly its top) should always be kept clean and dry.
    Fig 1: Precaution For Battery Surface
    G06444631Courtesy of SUZUKI OF AMERICA CORP.
  • The terminal connections should be clean and tight.
  • At every routine maintenance, check the electrolyte level.

    This also applies to batteries designated as "low maintenance" and "maintenance-free".

  • When the vehicle is not going to be used over a long period of time, disconnect the battery cable from the negative terminal. (If the vehicle has an extended storage switch, turn it off.)
    Fig 2: Identifying Battery Cable
    G06444632Courtesy of SUZUKI OF AMERICA CORP.
  • Check the charge condition of the battery.
    Fig 3: Checking Specific Gravity Of Electrolyte
    G06444633Courtesy of SUZUKI OF AMERICA CORP.

    Periodically check the specific gravity of the electrolyte. Keep a close check on charge condition to prevent over-discharge.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.