Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Suzuki SX4 Base, StandardFACTORY OEM SERVICE PROCEDURE
Tightening Torque Specifications
TIGHTENING TORQUE SPECIFICATIONS
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kgf-m | lbf-ft | |
| Tensioner bolt | 25 | 2.5 | 18.5 |
| Idler pulley bolt | 40 | 4.1 | 29.5 |
| Idler pulley nut | 40 | 4.1 | 29.5 |
| "B" terminal wire nut | 11 | 1.1 | 8.5 |
| Generator bolt | 45 | 4.6 | 33.5 |
| Power steering pump stay bolt | 25 | 2.5 | 18.5 |
NOTE:
The specified tightening torque is described in the following.
GENERATOR COMPONENTSΒ
GENERATOR COMPONENTSΒ
Reference:Β
For the tightening torque of fastener not specified in this section, refer to FASTENERS INFORMATION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
