2011 Suzuki SX4 4WD L4-2.0LFACTORY OEM SERVICE PROCEDURE

Control Module: Testing and Inspection




Inspection of 4WD Control Module and Its Circuits

4WD control module and its circuits can be checked at connector connected to 4WD control module by measuring voltage, pulse signal.

NOTE:

If you connect a voltmeter or ohmmeter directly to the 4WD control module terminals by removing the control module connectors, you can damage the control module.

Never connect a voltmeter or an ohmmeter directly to any terminal of the 4WD control module by disconnecting the control module connectors.

Voltage and Signal Check

1) Check voltage using voltmeter (1) connected to each terminal of connectors.
2) Check signal using oscilloscope (2) connected to each terminal of connectors.

NOTE:
- As each terminal voltage is affected by the battery voltage, confirm that it is 11 V or more when ignition switch is turned ON.
- Pulse signal cannot be measured by voltmeter. It can be measured by oscilloscope.
- Item with asterisk (*) in normal voltage column can be read only by oscilloscope.

Factory service manual diagram




Terminal arrangement of 4WD control module connector (Viewed from harness side)

Factory service manual diagram




Factory service manual diagram




Factory service manual diagram




Reference waveform No.1

Coupling assembly signal

Factory service manual diagram





Factory service manual diagram





Reference waveform No.2

CAN communication signal

Factory service manual diagram





Factory service manual diagram





Factory service manual diagram





Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.