Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Suzuki Grand Vitara BaseFACTORY OEM SERVICE PROCEDURE
DTC Detecting Condition and Trouble Area
NOTE:
After reprogramming of ECM is executed, if the DTC P0602 is indicated, it is possible that the reprogramming of ECM is not completed correctly.
P0602 DTC DETECTING CONDITION CHART
| DTC detecting condition | Trouble area |
|---|---|
| P0602: Control Module Programming Error ECM internal failure. (data programming error) (1 D/C detection logic but MIL does not light up) |
|
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.