2011 Suzuki Equator 2WD L4-2.5LFACTORY OEM SERVICE PROCEDURE

Power Window Main Switch




Power Window Main Switch: Removal and Installation

Removal

1) Using a suitable tool, release the metal clip and pawls, then lift upward the main power window/door lock switch and finisher (2) - LH as an assembly.

Factory service manual diagram




: Metal clip

: Pawl

CAUTION:
Wrap a cloth around suitable tool to protect components from damage.

2) Disconnect the harness connectors.
3) Remove the main power window/door lock switch and finisher (2) - LH assembly from the front door finisher.
4) Remove the three screws (A) from the main power window/door lock switch (1) - LH.
5) Remove the main power window/door lock switch (1) - LH from the main power window/door lock switch finisher (2) - LH.

Installation

Installation is in the reverse order of removal.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.