Body Control Module: Testing and Inspection

Body Control System: Configuration

Description

Vehicle specification needs to be written with SDT because it is not written after replacing BCM.

Configuration has three functions as follows

- READ CONFIGURATION is the function to read (extract) vehicle configuration of current BCM.
- WRITE CONFIGURATION - Manual setting is the function to select and write vehicle configuration on BCM manually.
- WRITE CONFIGURATION - Config file is the function to write vehicle configuration with the data extracted from current BCM.

CAUTION:

- When replacing BCM, you must perform WRITE CONFIGURATION with SDT.
- Complete the procedure of WRITE CONFIGURATION in order.
- If you set incorrect WRITE CONFIGURATION, incidents will occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.

Special Repair Requirement

1. WRITING VEHICLE SPECIFICATION

Perform "WRITE CONFIGURATION" with SDT.

When writing saved data
GO TO 2
When writing manually
GO TO 3

2. PERFORM "WRITE CONFIGURATION - Config file"

Perform "WRITE CONFIGURATION - Config file" with SDT.


Work End.

3. PERFORM "WRITE CONFIGURATION - Manual setting"

For "WRITE CONFIGURATION - Manual setting", using the following chart, identify the correct model and configuration list.

Confirm and/or change setting value for each item according to the configuration list.

Depending on SDT software version being used, some or all of the write configuration items shown in the following configuration lists may be displayed. If an item does not display on the SDT "WRITE CONFIGURATION - Manual setting" screen, then it is an auto setting item and it cannot be manually set or changed.






NOTE:
Confirm vehicle model. Refer to [Identification Information: Model Variation] Model Variation.


Work End.