Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Suzuki SX4 Base, StandardFACTORY OEM SERVICE PROCEDURE
Starting Motor Inspection: Spring
Check brush springs for wear, damage or other abnormal conditions. Replace brush assembly if necessary.
Brush spring tension
Standard: 15 - 20 N (1.5 kgf - 2.0 kgf, 3.4 - 4.5 lbf)
Limit: 2.8 N (0.29 kgf, 0.63 lbf)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
