Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2010KIZASHI FWD L4-2.4LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS STARTING SYSTEMSERVICE AND REPAIR
2010 Suzuki Kizashi FWD L4-2.4L
Keyless Starting System: Service and Repair
2010 Suzuki Kizashi FWD L4-2.4LSECTION Service and Repair
Security Alarm Mode Selection Procedure
Security alarm mode can be selected by performing the following procedure.
NOTE: Security alarm mode can also be selected by setting change function of SUZUKI scan tool.
1. Confirm that all doors are closed, hood is closed, trunk lid is closed, all doors are unlocked and lighting switch OFF.
2. Push engine switch to change ignition mode to "ON".
3. Perform the following steps within 15 seconds.
a. Turn lighting switch to "CLEARANCE" position.
b. Turn lighting switch to "OFF" position.
c. Repeat Step a and b 3 times.
d. Operate driver door lock knob (1) to "LOCK" position.
e. Operate driver door lock knob to "UNLOCK" position.
f. Repeat Step d and e once.
g. Operate driver door lock knob to "LOCK" position.
4. When Step 3 is completed, the mode changes automatically. Warning buzzer (in combination meter) sounds by the number of specified for each mode as follows.
- Changed from "Passive" mode to "Active" mode: Buzzer sounds 4 times.
- Changed from "Active" mode to "Passive" mode: Buzzer sounds once.
Security alarm mode can be selected by performing the following procedure.
NOTE: Security alarm mode can also be selected by setting change function of SUZUKI scan tool.
1. Confirm that all doors are closed, hood is closed, trunk lid is closed, all doors are unlocked and lighting switch OFF.
2. Push engine switch to change ignition mode to "ON".
3. Perform the following steps within 15 seconds.
a. Turn lighting switch to "CLEARANCE" position.
b. Turn lighting switch to "OFF" position.
c. Repeat Step a and b 3 times.
d. Operate driver door lock knob (1) to "LOCK" position.
e. Operate driver door lock knob to "UNLOCK" position.
f. Repeat Step d and e once.
g. Operate driver door lock knob to "LOCK" position.
4. When Step 3 is completed, the mode changes automatically. Warning buzzer (in combination meter) sounds by the number of specified for each mode as follows.
- Changed from "Passive" mode to "Active" mode: Buzzer sounds 4 times.
- Changed from "Active" mode to "Passive" mode: Buzzer sounds once.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.