Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Replacement Of Remote Controller Battery
2010 Suzuki Kizashi FWD L4-2.4LSECTION Replacement Of Remote Controller Battery
Replacement of Remote Controller Battery
1. Remove emergency key (4).
2. Remove upper case (1) using a flat-end screwdriver as shown in figure.
3. Remove printed circuit board (2) from lower case (3).
4. Remove battery (2) using a flat-end screwdriver (1) as shown in figure.
5. Place battery (lithium disc-type CR 2032 or equivalent) (1) so its "-" terminal faces "-" mark of the printed circuit board (2).
6. Install printed circuit board to lower case and then fit upper case securely.
NOTE: Dispose of the used battery properly according to applicable rules or regulations. Do not dispose of lithium batteries with ordinary household trash.
1. Remove emergency key (4).
2. Remove upper case (1) using a flat-end screwdriver as shown in figure.
3. Remove printed circuit board (2) from lower case (3).
4. Remove battery (2) using a flat-end screwdriver (1) as shown in figure.
5. Place battery (lithium disc-type CR 2032 or equivalent) (1) so its "-" terminal faces "-" mark of the printed circuit board (2).
6. Install printed circuit board to lower case and then fit upper case securely.
NOTE: Dispose of the used battery properly according to applicable rules or regulations. Do not dispose of lithium batteries with ordinary household trash.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.