Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Suzuki Equator 2WD L4-2.5LFACTORY OEM SERVICE PROCEDURE
System Specifications
Chain tensioner 7.0 Nm (0.71 kgf-m, 62 in lb)
Timing cover
Bolt position Bolt length
5, 10, 14, 17 45 mm (1.77 in)
Except the above (Except 1 through 4) 20 mm (0.79 in)
Bolt position Torque specification
5 through 17 12.8 Nm (1.3 kg-m, 9 ft-lb)
1 through 4 49.0 Nm (5.0 kg-m, 36 ft-lb)
After all bolts are tightened, retighten them to the specified torque in numerical order as shown
Crankshaft pulley
Tighten 42.1 Nm (4.3 kg-m, 31 ft-lb)
Angle tightening 60 degrees
Timing cover
Bolt position Bolt length
5, 10, 14, 17 45 mm (1.77 in)
Except the above (Except 1 through 4) 20 mm (0.79 in)
Bolt position Torque specification
5 through 17 12.8 Nm (1.3 kg-m, 9 ft-lb)
1 through 4 49.0 Nm (5.0 kg-m, 36 ft-lb)
After all bolts are tightened, retighten them to the specified torque in numerical order as shown
Crankshaft pulley
Tighten 42.1 Nm (4.3 kg-m, 31 ft-lb)
Angle tightening 60 degrees
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.