Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Suzuki Equator 2WD L4-2.5LFACTORY OEM SERVICE PROCEDURE
Spark Plug: Service and Repair
Spark Plug Removal and Installation [QR25DE]
Removal
1. Remove the intake manifold (except for spark plug No.1).
2. Remove the ignition coil.
3. Remove the spark plug using a suitable tool.

CAUTION: Do not drop or shock it.
Inspection after Removal
- Do not use a wire brush for cleaning.

- If the spark plug tip is covered with carbon, spark plug cleaner may be used.
Cleaner air pressure : Less than 588 kPa (5.9 bar, 6 kg/cm2, 85 psi)
Cleaning time : Less than 20 seconds
- Checking and adjusting spark plug gap is not required between change intervals.

Installation
Installation is in the reverse order of removal.
CAUTION: Do not drop or shock the spark plug.

Removal
1. Remove the intake manifold (except for spark plug No.1).
2. Remove the ignition coil.
3. Remove the spark plug using a suitable tool.
CAUTION: Do not drop or shock it.
Inspection after Removal
- Do not use a wire brush for cleaning.
- If the spark plug tip is covered with carbon, spark plug cleaner may be used.
Cleaner air pressure : Less than 588 kPa (5.9 bar, 6 kg/cm2, 85 psi)
Cleaning time : Less than 20 seconds
- Checking and adjusting spark plug gap is not required between change intervals.
Installation
Installation is in the reverse order of removal.
CAUTION: Do not drop or shock the spark plug.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
