2010 Suzuki Equator 2WD L4-2.5LFACTORY OEM SERVICE PROCEDURE

Control Assembly: Service and Repair

Control Unit: Removal and Installation

Front Air Control

Removal
1. Remove cluster lid C. Refer to [Instrument Panel Assembly: Exploded View].
2. Remove the front air control from cluster lid C.
- For type 1, remove the four screws (A) securing the front air control (1) to cluster lid C.

Factory service manual diagram





- For type 2, remove the four screws securing the front air control to cluster lid C.

Factory service manual diagram





Installation
Installation is in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.