Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Suzuki XL7 Base, AWDFACTORY OEM SERVICE PROCEDURE
IMOBILIZER Control System DTCS
IMOBILIZER CONTROL SYSTEM DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | Description |
|---|---|
| B3006 | Hood Ajar Circuit Plausibility Failure |
| B302A | Telematic Requested Immobilization |
| B3031 | Security System Controller In Learn Mode |
| B3055 | No Transponder Modulation or No Transponder |
| B3060 | Unprogrammed Transponder Identification Code Received |
| B3935 | Transponder Authentication Error |
| B3976 | Unconfigured Transponder/Vehicle Configuration Not Programmed |
| P0513 | Theft Deterrent Key Incorrect |
| P0633 | Theft Deterrent Key Not Programmed |
| P1629 | Theft Deterrent Fuel Enable Signal Not Received |
| P1630 | Theft Deterrent Learn Mode Active |
| P1631 | Theft Deterrent Fuel Enable Signal Not Correct |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
