Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Suzuki Forenza L4-2.0LFACTORY OEM SERVICE PROCEDURE
Mode 6 Data
MODE $06 Diagnostic Description
Catalyst Monitor Bank 1:
Misfire Cylinder 1 Data:
Misfire Cylinder 2 Data:
Misfire Cylinder 3 Data:
Misfire Cylinder 4 Data:
EVAP Monitor (Cap Off):
EVAP Monitor (0.040" Leak):
EVAP Monitor (0.020" Leak):
Purge Flow Monitor:
Oxygen Sensor Heater Monitor Bank 1 Sensor 1:
Oxygen Sensor Heater Monitor Bank 1 Sensor 2:
EGR Monitor Bank 1:
Supported MID Range:
Refer to SAE J1979 / ISO 15031 - 5 document which shows the available MIDs, TIDs and Unit Scaling IDs available for implementation of OBDII over CAN
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.