Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Suzuki SX4 Base, StandardFACTORY OEM SERVICE PROCEDURE
BARTEC TPMS Reset Procedure
NOTE:
Once OBD initializes, you will have 90 seconds to complete sensor activations!
OBD Connect: Assisted Relearn
- Inflate Tires to correct pressure.
- Following on tool prompts, activate sensors to insure they are working.
- Tool will prompt you to connect to OBDII and turn ignition to ON.NOTE: Reminder: you have 90 seconds to complete this next action.
- Continue to follow the tool prompts with the tool connected, using a 2nd activation tool activate the sensor as indicated on the tool screen.
- Once completed the tool will indicate successful relearn.
- Verify TPMS light is off.
(2nd Tool is REQUIRED.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.