2007 Suzuki SX4 Base, StandardFACTORY OEM SERVICE PROCEDURE

Keyless Start Control Module Power And Ground Circuit Check: Troubleshooting

WARNING: This page is about a different car, the 2006 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
TROUBLESHOOTING CHART

Step Action YES NO
1  Fuse check 
  1. Turn ignition switch to OFF position.
  2. Check circuit fuse and main fuse for condition.

Are fuses in good condition? 
Go to Step 2. Replace fuse(s) and check for short.
2  Power supply circuit check 
  1. Disconnect connector from keyless start control module.
  2. Check for proper connection to "G44-10", "G44-11" and "G44-15" terminals of keyless start control module connector.
  3. If OK, measure voltage between the following terminals.
    • When ignition switch is at OFF position Between "G44-10" terminal of keyless start control module connector and vehicle body ground: 10 - 14 V
    • When ignition switch is at ACC position Between "G44-11" terminal of keyless start control module connector and vehicle body ground: 10 - 14 V
    • When ignition switch is at ON position Between "G44-15" terminal of keyless start control module connector and vehicle body ground: 10 - 14 V

Is check result satisfactory? 
Go to Step 3. Repair power supply circuit.
3  Ground circuit check 
  1. Check for proper connection to "G44-9" terminal of keyless start control module connector.
  2. If OK, measure resistance between "G44-9" terminal of keyless start control module connector and vehicle body ground.

Is resistance 1 Ω or less? 
Power and ground circuit is in good condition. Repair ground circuit.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.