Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Suzuki SX4 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Automatic Transaxle Unit Assembly

Reference: AUTOMATIC TRANSAXLE UNIT DISMOUNTING AND REMOUNTING

Reference: AUTOMATIC TRANSAXLE UNIT DISASSEMBLY

Apply lithium grease to new manual shift shaft oil seal lip.
: Grease 99000-25030SUZUKI Super Grease C
Press-fit new manual shift shaft oil seal (1) to transaxle case, using special tool.
Special Tool

(A): 09943-88211

Fig 1: Identifying Manual Shift Shaft Oil Seal
Courtesy of SUZUKI OF AMERICA CORP.
Apply A/T fluid to new oil seal rings (1) and install oil seal rings (1) to transaxle case.
NOTE: Do not spread oil seal ring ends excessively.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.