Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Suzuki SX4 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
DTC Troubleshooting
DTC TROUBLESHOOTING TABLE
| Step | Action | YES | NO |
|---|---|---|---|
| 1 | DTC check
Is DTC P0602 or P1702 still detected? |
Substitute a known-good TCM and recheck. | Intermittent trouble. Check for intermittent by referring to INTERMITTENT AND POOR CONNECTION INSPECTION . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.