Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Suzuki Reno AutomaticFACTORY OEM SERVICE PROCEDURE
DTC P0604: Internal Control Module Random Access Memory (RAM) Error: Troubleshooting
TROUBLESHOOTING REFERENCE CHART
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 | Perform an On-Board Diagnostic (OBD II) System Check. Is the check completed? |
- | Go to Step 2 | Go to ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK |
| 2 |
Does the scan tool display P0604? |
- | Go to Step 3 | Go to DIAGNOSTIC AIDS |
| 3 |
Is the action complete? |
- | Go to Step 4 | - |
| 4 |
Does the scan tool indicate that this diagnostic has run and passed? |
- | Go to Step 5 | Go to Step 2 |
| 5 | Check if any DTCs are set. Are any DTCs displayed that have not been diagnosed? |
- | Go to applicable DTC table | System OK |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
