2007 Suzuki Aerio Base, AWDFACTORY OEM SERVICE PROCEDURE

Electronic Control System Description: Notes

The electronic control system consists of various sensors which detect the state of engine and driving conditions, ECM which controls various devices according to the signals from the sensors and various controlled devices referring to ELECTRONIC CONTROL SYSTEM COMPONENTS LOCATIONΒ .

Functionally, it is divided into the following sub systems:

  • Fuel injection control system
  • Ignition control system
  • Idle air control system
  • Fuel pump control system
  • Radiator fan control system
  • Evaporative emission control system
  • EGR system
  • Heated oxygen sensor heater control system
  • A/C control system
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.