Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Suzuki Verona BaseFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System DTCS
ABS ANTI-LOCK BRAKE SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Check Point (Value) |
|---|---|---|
| DTC C1101: BATTERY VOLTAGE TOO HIGH | Battery voltage too high | 16 V or higher |
| DTC C1102: BATTERY VOLTAGE TOO LOW | Battery voltage too low | 9.4 V or lower |
| DTC C1200: LEFT FRONT WHEEL SPEED SENSOR CIRCUIT OPEN OR SHORTED | Left front wheel speed sensor circuit open or shorted | Sensor, Wiring Harness, Connector |
| DTC C1201: LEFT FRONT WHEEL SPEED EXCESSIVE VARIATION | Left front wheel speed excessive variation | Sensor, Wiring Harness, Connector, Airgap |
| DTC C1202: LEFT FRONT WHEEL SPEED SENSOR NO SIGNAL | Left front wheel speed sensor no signal | Sensor, Wiring Harness, Connector, Airgap, EBCM |
| DTC C1203: RIGHT FRONT WHEEL SPEED SENSOR CIRCUIT OPEN OR SHORTED | Right front wheel speed sensor circuit open or shorted | Sensor, Wiring Harness, Connector |
| DTC C1204: RIGHT FRONT WHEEL SPEED EXCESSIVE VARIATION | Right front wheel speed excessive variation | Sensor, Wiring Harness, Connector, Airgap |
| DTC C1205: RIGHT FRONT WHEEL SPEED SENSOR NO SIGNAL | Right front wheel speed sensor no signal | Sensor, Wiring Harness, Connector, Airgap, EBCM |
| DTC C1206: LEFT REAR WHEEL SPEED SENSOR CIRCUIT OPEN OR SHORTED | Left rear wheel speed sensor circuit open or shorted | Sensor, Wiring Harness, Connector |
| DTC C1207: LEFT REAR WHEEL SPEED EXCESSIVE VARIATION | Left rear wheel speed excessive variation | Sensor, Wiring Harness, Connector, Airgap |
| DTC C1208: LEFT REAR WHEEL SPEED SENSOR NO SIGNAL | Left rear wheel speed sensor no signal | Sensor, Wiring Harness, Connector, Airgap, EBCM |
| DTC C1209: RIGHT REAR WHEEL SPEED SENSOR CIRCUIT OPEN OR SHORTED | Right rear wheel speed sensor circuit open or shorted | Sensor, Wiring Harness, Connector |
| DTC C1210: RIGHT REAR WHEEL SPEED EXCESSIVE VARIATION | Right rear wheel speed excessive variation | Sensor, Wiring Harness, Connector, Airgap |
| DTC C1211: RIGHT REAR WHEEL SPEED SENSOR NO SIGNAL | Right rear wheel speed sensor no signal | Sensor, Wiring Harness, Connector, Airgap, EBCM |
| DTC C1503: TCS SWITCH ERROR | TCS Switch Error | TCS Switch, Connector, Wiring Harness |
| DTC C1604: EBCM INTERNAL FAULT | EBCM internal fault | EBCM |
| DTC C1605 / C1611 / C1612 / C1616: CAN HARDWARE ERROR / CAN TIME-OUT EMS / CAN TIME-OUT TCU / CAN BUS OFF | CAN Hardware Error | EBCM, Connector |
| DTC C1605 / C1611 / C1612 / C1616: CAN HARDWARE ERROR / CAN TIME-OUT EMS / CAN TIME-OUT TCU / CAN BUS OFF | CAN time - out EMS | EBCM, Connector |
| DTC C1605 / C1611 / C1612 / C1616: CAN HARDWARE ERROR / CAN TIME-OUT EMS / CAN TIME-OUT TCU / CAN BUS OFF | CAN time - out TCU | EBCM, Connector |
| DTC C1605 / C1611 / C1612 / C1616: CAN HARDWARE ERROR / CAN TIME-OUT EMS / CAN TIME-OUT TCU / CAN BUS OFF | CAN bus off | EBCM, Connector |
| DTC C2112 / C2380: VALVE RELAY OR FUSE FAILURE / ABS / TCS VALVE ERROR | Valve relay or fuse failure | Fuse, EBCM |
| DTC C2112 / C2380: VALVE RELAY OR FUSE FAILURE / ABS / TCS VALVE ERROR | ABS / TCS Valve error | EBCM, Connector |
| DTC C2402: PUMP MOTOR FAILURE C2402 | Pump motor failure | Motor, Fuse, Connector |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.