Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Suzuki Verona BaseFACTORY OEM SERVICE PROCEDURE
Engine Coolant Temperature Sensor Removal
- Relieve the pressure in the coolant reservoir by turning the coolant reservoir cap slightly counterclockwise.
- Disconnect the negative battery cable.
- Remove the VIS vacuum tank. Refer to VIS Vacuum Tank Removal Z.
- Disconnect the engine coolant temperature sensor (ECTS) connector.
- Remove the ECTS from the cylinder head.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.