Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Suzuki Verona BaseFACTORY OEM SERVICE PROCEDURE
Main Relay Circuit Check: Troubleshooting
TROUBLESHOOTING CHART
| Step | Action | Value (s) | Yes | No |
|---|---|---|---|---|
| 1 |
Is the test light ON at both terminals? |
- | System OK | Go to Step 2. |
| 2 | Check the test light. Is the test light ON at only one terminal? |
- | Go to Step 9. | Go to Step 3. |
| 3 | Check the test light. Is the test light OFF at both terminals? |
- | Go to Step 4. | - |
| 4 |
Is the fuse OK? |
- | Go to Step 5. | Go to Step 10. |
| 5 |
Is the test light ON? |
- | Go to Step 6. | Go to Step 11. |
| 6 | Connect a test light between the main relay connector terminal 85 and battery voltage. Is the test light ON? |
- | Go to Step 7. | Go to Step 12. |
| 7 | Connect a test light between the main relay connector terminal 30 and ground. Is the test light ON? |
- | Go to Step 8. | Go to Step 13. |
| 8 | Check for an open in the wiring between the main relay connector terminal 87 and the engine fuse block terminals for fuses Ef24 and Ef27. Is the problem found? |
- | Go to Step 9. | Go to Step 14. |
| 9 | Repair the open in the wiring between the main relay connector terminal 87 and the engine fuse block terminal(s) for fuses Ef24 and Ef27. Is the repair complete? |
- | System OK | - |
| 10 | Replace the engine fuse block fuse Ef30. Is the repair complete? |
- | System OK | - |
| 11 | Repair the open in the wiring between the main relay connector terminal 86 and the ignition switch. Is the repair complete? |
- | System OK | - |
| 12 | Repair the open in the wiring between the main relay connector terminal 85 and ground. Is the repair complete? |
- | System OK | - |
| 13 | Repair the open in the wiring between the main relay connector terminal 30 and the battery. Is the repair complete? |
- | System OK | - |
| 14 | Replace the main relay. Is the repair complete? |
- | System OK | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
