2006 Suzuki Verona BaseFACTORY OEM SERVICE PROCEDURE

Dieseling, Run-On

DEFINITION:Β 

An engine continues to run after the ignition switch is turned OFF.Β 

DIESELING, RUN-ON - DIAGNOSIS PROCEDURE

Step Action Value(s) Yes No
1 Were the Important Preliminary Checks performed? - Go to Step 2. Go to Symptom DiagnosisΒ .
2 Does the engine run smoothly after the ignition switch is turned OFF? - Go to Step 3. Go to Step 4.
3
  1. Check the ignition switch and the ignition switch adjustment.
  2. Replace the ignition switch if needed.

Is the repair complete?
- System OK -
4
  1. Check the evaporative emission system.
  2. Check for leaking fuel injectors.
  3. Check the Idle Air Control (IAC) valve operation.
  4. Inspect for vacuum leaks.
  5. Check for the proper base idle setting.

Are all checks and repairs complete?
- System OK -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.