Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Suzuki Verona L6-2.5LFACTORY OEM SERVICE PROCEDURE
Intake Manifold
Intake Manifold Retaining Bolt/Nut 10 - 14 Nm (89 - 124 inch lbs.)
Intake Manifold Support Bracket Bolt 20 - 30 Nm (15 - 22 ft. lbs.)
Throttle Body Bolt 8 - 18 Nm (6 - 13 ft. lbs.)

Tighten the intake manifold retaining nuts and bolts.
Tighten the seven (7) intake manifold retaining bolts 10 - 14 Nm (89 - 124 inch lbs.)
Tighten the four (4) intake manifold retaining nuts 10 - 14 Nm (89 - 124 inch lbs.)
Tighten the two (2) bolts on the intake manifold support bracket 10 - 14 Nm (89 - 124 inch lbs.)
Intake Manifold Support Bracket Bolt 20 - 30 Nm (15 - 22 ft. lbs.)
Throttle Body Bolt 8 - 18 Nm (6 - 13 ft. lbs.)
Tighten the intake manifold retaining nuts and bolts.
Tighten the seven (7) intake manifold retaining bolts 10 - 14 Nm (89 - 124 inch lbs.)
Tighten the four (4) intake manifold retaining nuts 10 - 14 Nm (89 - 124 inch lbs.)
Tighten the two (2) bolts on the intake manifold support bracket 10 - 14 Nm (89 - 124 inch lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
