SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2005VERONA L6-2.5LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULESERVICE AND REPAIR
2005 Suzuki Verona L6-2.5L

Engine Control Module: Service and Repair

2005 Suzuki Verona L6-2.5LSECTION Service and Repair
Engine Control Module (ECM) Removal And Installation

Engine Control Module (ECM) Removal

1. Remove the battery.




2. Remove the ECM bracket nuts.
3. Disconnect the ECM connector.




4. Remove the ECM retaining nuts and the ECM.

Engine Control Module (ECM) Installation

1. Installation should follow the removal procedure in the reverse order.




2. Install the ECM.

Tighten:
Tighten the ECM retaining nuts to 10 ~ 14 N.m (89 ~ 124 lb.in).




3. Tighten the ECM bracket nuts.

Tighten:
Tighten the ECM bracket nuts to 10 ~ 14 N.m (89 ~ 124 lb.in).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.