2005 Suzuki Verona L6-2.5LFACTORY OEM SERVICE PROCEDURE

Engine Control Module: Service and Repair

Engine Control Module (ECM) Removal And Installation

Engine Control Module (ECM) Removal

1. Remove the battery.

Factory service manual diagram



2. Remove the ECM bracket nuts.
3. Disconnect the ECM connector.

Factory service manual diagram



4. Remove the ECM retaining nuts and the ECM.

Engine Control Module (ECM) Installation

1. Installation should follow the removal procedure in the reverse order.

Factory service manual diagram



2. Install the ECM.

Tighten:
Tighten the ECM retaining nuts to 10 ~ 14 N.m (89 ~ 124 lb.in).

Factory service manual diagram



3. Tighten the ECM bracket nuts.

Tighten:
Tighten the ECM bracket nuts to 10 ~ 14 N.m (89 ~ 124 lb.in).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.