Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2005VERONA EXREPAIR AND DIAGNOSISQUICK LOOKUPSDTC INDEXANTI-LOCK BRAKE DTCS
2005 Suzuki Verona EX
Anti-Lock Brake DTCS
2005 Suzuki Verona EXSECTION Anti-Lock Brake DTCS
ANTI-LOCK BRAKE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Check Point (Value) |
|---|---|---|
| C1101 | Battery voltage too high | 16 V or higher |
| C1102 | Battery voltage too low | 9.4 V or lower |
| C1200 | Left front wheel speed sensor circuit open or shorted | Sensor, Wiring Harness, Connector |
| C1201 | Left front wheel speed excessive variation | Sensor, Wiring Harness, Connector, Airgap |
| C1202 | Left front wheel speed sensor no signal | Sensor, Wiring Harness, Connector, Airgap, EBCM |
| C1203 | Right front wheel speed sensor circuit open or shorted | Sensor, Wiring Harness, Connector |
| C1204 | Right front wheel speed excessive variation | Sensor, Wiring Harness, Connector, Airgap |
| C1205 | Right front wheel speed sensor no signal | Sensor, Wiring Harness, Connector, Airgap, EBCM |
| C1206 | Left rear wheel speed sensor circuit open or shorted | Sensor, Wiring Harness, Connector |
| C1207 | Left rear wheel speed excessive variation | Sensor, Wiring Harness, Connector, Airgap |
| C1208 | Left rear wheel speed sensor no signal | Sensor, Wiring Harness, Connector, Airgap, EBCM |
| C1209 | Right rear wheel speed sensor circuit open or shorted | Sensor, Wiring Harness, Connector |
| C1210 | Right rear wheel speed excessive variation | Sensor, Wiring Harness, Connector, Airgap |
| C1211 | Right rear wheel speed sensor no signal | Sensor, Wiring Harness, Connector, Airgap, EBCM |
| C1503 | TCS Switch Error | TCS Switch, Connector, Wiring Harness |
| C1604 | EBCM internal fault | EBCM |
| C1605 | CAN Hardware Error | EBCM, Connector |
| C1611 | CAN time - out EMS | EBCM, Connector |
| C1612 | CAN time- out TCU | EBCM, Connector |
| C1616 | CAN bus off | EBCM, Connector |
| C2112 | Valve relay or fuse failure | Fuse, EBCM |
| C2380 | ABS / TCS Valve error | EBCM, Connector |
| C2402 | Pump motor failure | Motor, Fuse, Connector |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.