Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmitter Programming Procedure
2005 Suzuki Swift +SECTION Transmitter Programming Procedure
- Turn ON the ignition with the engine OFF.
- Install the scan tool.
- Select PROGRAMMING KEY FOBS from the BODY menu.
- Follow the scan tool instructions with each key until all keys are programmed.
- Turn the ignition to the LOCK position, disconnect the TECH 2 and test all the keys.
- If any key does not function, refer to Keyless Entry Does Not Program .
IMPORTANT:
Turn the ignition to ON before installing in the scan tool. Failure to connect in this procedure may cause communication errors and the programming procedure will not complete. Any keys that are not programmed at this time will no longer function.
For immobilizer programming, refer to Programming Additional Keys in Theft Deterrent System
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.