SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2005SWIFT +REPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEMREPAIR INSTRUCTIONSTRANSMITTER PROGRAMMING (SCAN 100)
2005 Suzuki Swift +

Transmitter Programming (Scan 100)

2005 Suzuki Swift +SECTION Transmitter Programming (Scan 100)

The remote keyless entry system allows for the use of as many a five transmitters for each vehicle. Replacement remote keyless entry system transmitters must be first programmed to the specific vehicle using the scan tool.

This process is completed using serial data communication between the scan tool and the remote keyless entry control unit and is the only method available for programming transmitters.

    IMPORTANT: All transmitters that are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to five transmitters can be programmed. Do no operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.