2005 Suzuki Reno L4-2.0LFACTORY OEM SERVICE PROCEDURE

Control Assembly Knob Lighting

Control Assembly Knob Lighting Removal and Installation

Removal
1. Disconnect the negative battery cable.
2. Remove the center molding.

Factory service manual diagram



3. Turn the bulb holder to the left and pull out the bulb.

Installation
1. Install the bulb into the holder and turn the bulb to the right.
2. Install the control assembly.
3. Connect the negative battery cable.

Factory service manual diagram



4. Check the knob light for proper operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.