Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Control Module Removal and Installation: Installation
2005 Suzuki Reno EXSECTION Installation
- Connect the ECM connectors to the ECM.
- Align the ECM into the mounting base.
- Snap the ECM into its mounting base.
- Install the ECM trim locks.
- Install the air intake tube and resonator.
- Connect the negative battery cable.
- Perform a crankshaft position system variation learning procedure. Refer to "TEC (TOOTH ERROR CORRECTION) LEARN PROCEDURE :".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.