Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Suzuki Vitara 4WD, AutomaticFACTORY OEM SERVICE PROCEDURE
Throttle Position (TP) Sensor Adjustment
- Warm up engine to normal operating temperature.
- Make sure that fast idle cam and cam follower lever are not in contact with each other. If they are, check fast idle control system.
- Loosen TP sensor screws.
- Remove ECM (PCM) cover from bracket.
- Turn TP sensor (1) clockwise or counterclockwise and tighten TP sensor screw at a position where voltage as specified in the following is obtained at coupler terminal "C51-3-12".NOTE: If SUZUKI scan tool is available, make an adjustment by using SUZUKI scan tool while observing TP sensor voltage.
TP sensor voltage when throttle is fully close
0.50 +/- 0.15 V
Tightening torque
TP sensor screw (a): 2.5 N.m (0.25 kg-m, 1.8 lb-ft)
- Make sure that TP sensor voltage is as shown below when throttle is fully open.
TP sensor voltage when throttle is fully open
4.0 +/- 0.5V
- Install ECM (PCM) cover.
- Disconnect negative cable at battery for 30 seconds or more, and then connect negative cable at battery.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
