Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Suzuki Verona EXFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS ⁽¹⁾

Application

Preferred

Range

Camber (Reference) ⁽²⁾

Front

-.5

-1.5 To .5

Rear

-1.5

-2.5 To -.5

Caster (Reference) ⁽²⁾

2 To 4

Toe-In ⁽²⁾

Front

-.07 To .27

Rear

.15

-.02 To .32

Toe-In ⁽³⁾

Front

.5 (1.3)

-.035 (-.9) To .135 (3.4)

Rear

.075 (1.9)

.01 (.25) To .16 (4)

⁽¹⁾	Wheel alignment specifications are with the vehicle in a normally loaded condition. Prior to inspection or alignment, place a weight of approximately 150 lbs. (68 kg) on each front seat cushion.

⁽²⁾	Measurement in degrees.

⁽³⁾	Measurement in inches (mm).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.